Manufactured Wood Products
Plywood standard building grade plywood is a material that usually does not produce an acceptable result when engraved. It is also a very difficult material to cut. Since the grain of the wood chips in
the plywood run in different directions, it is difficult to obtain a consistent depth when engraving. Air
bubbles within the plywood cause problems because they severely disrupt the laser beam when
cutting. Because of the air bubbles it is virtually impossible to cut cleanly through standard plywood
There are specialty plywood products that can be found in hobby shops or specialty wood stores
 that will engrave and cut much nicer than standard plywood products purchased through your local lumber supplier.
 

Back to Cutting Page

Home Page  Engraving  Cutting  Products  Info Request  Email Us